Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
do you mean on a single/double sided board? if so just goto Place/Polygon. setup you minimum grid (0 for solid) and track size/angle. select Gnd (or whatever you called it) in the net selector. select pour over same net and remove dead copper and away you go.
if you mean on a multilayer board (a gnd plane) you need to set it up in the layer stack manager
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
