Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

MOSFET gate discharge circuit

Status
Not open for further replies.
E

eem2am

Banned
Joined
Jun 22, 2008
Messages
1,179
Helped
37
Reputation
74
Reaction score
24
Trophy points
1,318
Activity points
0
mosfet gate discharge

hello

i am making an LED driver and i wonder if my mosfet driver will turn the fet off quickly enough?

as you see below if you want........do you know what resistance the mosfet sees looking back into the emitter follower stage?......am i right to saying that it sees 500 Ohms/hfe ....ie 500/100 = 5 Ohms ?

5f4xs1.jpg


thanking for any thoughts
 

mosfet gate follower

The circuit has more serious flaws than slow turn off. First of all, it doesn't turn the FET on completely. Depending on the threshold voltage, it most likely stays permanently off. The maximum gate voltage from this circuit is about 1.8 V, with no drain current, reduced by the sense resistor voltage drop.

You should at least supply undivided 5 V to the gate, if it's a logic level FET with a low threshold voltage.
Faster turn off may be achieved by a push-pull gate driver, may be advisable for a high switching frequency.
 

gate discharge

These are proper discrete drivers.

25po9s0.png


Or use a mosfet gate driver IC.

* EDIT You have twelve volts available put the collector of the NPN (fig 23) to the twelve volt rail. As long as your FET can take the Vgs.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top