Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Design An Oscilloscope

Status
Not open for further replies.
W

wf_car

Newbie level 4
Joined
Sep 18, 2008
Messages
7
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,319
Hi,everyone.
I want to do some research in electronic design, so I need an oscilloscope, even a very simple one. I want to make one by my self, I have designed some instruments like signal generator and so on, but I don't know how much process should be done before A/D convert.
Thanks for your help!:D
 

What is the maximum frequency requirement? This will make a big difference. If it only a few Mhz then there are some fairly simple projects that can be found on the www.
 

Thanks very much!I used to design some industrial control system with microcontroller, usually works at 24Mhz, the communication based on CAN bus was less than 1Mhz,so I think 50Mhz is my maximum frequency requirement.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top