Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Help me create in-ports for power combiner simulation in HFSS

Status
Not open for further replies.
T

tadeupasetto

Junior Member level 2
Joined
Mar 26, 2008
Messages
21
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,283
Activity points
1,403
I have a project for a power combiner and I'd like to simulate it in HFSS, but the inner at the in-port isn't in the port ( it's only a connector).

I try to put one 50ohms inner conected, but the results isn't so good.
 

Re: Simulate Ports - More information

'm sending a image of the 3d model of this combiner.

the out-port is in Z-axis and de in-ports is in the x-axis.

bus I dont know to create the in-ports, because the square connector is internal (it haves a conector to the EIA 6 1/8'' 50ohms)

Please, somebody help me!!!!!!!!!
 

Re: Simulate Ports

I tried it, but the resulted was bad

and it's for high-power, and I read that lumped ports is used to MS..
 

Simulate Ports

Hi,

With my little experience on HFSS, I think you can make a simulation with a deembed. You to continu the square connector to the external like olong z axis an thenmake your port and with a deembed.

Good luck,

PAF
 

Simulate Ports

Hi tadeupasetto
There are lot of HFSS tutorials posted in this forum
You will definitely find the solution by reading the tutorials.
May be, I think you have not defined the port correctly.
Also I would recommand that place the same topic in this forum part


there are lot of experts on HFSS browsing that part.
Best of luck
ABhishekabs
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top