yschuang
Full Member level 3
Hi, all
I am working on voltage doulber. There is a problem when I add the ESR shown in the figure. The voltage of the output can not be inverted or goes below zero and stayes at high. The voltage is supposed to be inverted @ -Vin. When I remove the ESR, everything goes right. The value of ESR is 0.1m ohm and of C is 10uF.
For more details like the operation, go to **broken link removed**
Thanks
I am working on voltage doulber. There is a problem when I add the ESR shown in the figure. The voltage of the output can not be inverted or goes below zero and stayes at high. The voltage is supposed to be inverted @ -Vin. When I remove the ESR, everything goes right. The value of ESR is 0.1m ohm and of C is 10uF.
For more details like the operation, go to **broken link removed**
Thanks