Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Coaxial feed in Feko design!

Status
Not open for further replies.
K

KhangKhang

Member level 2
Joined
Jan 4, 2007
Messages
48
Helped
1
Reputation
2
Reaction score
0
Trophy points
1,286
Activity points
1,612
feko coaxial

Does anyone experience coaxial cable feeding design in Feko?
Let's say if I wanna design a coaxial cable undernearth the infinite ground plane and use the inner conductor for antena excitation!
It is quite easy in MWS, but in FEKO...:cry:
Please share me any example or any advice!
Thanks in advance!
 

feko coaxial feed

im having the same problem.... i think the A4 card on EDITFEKO models a coaxial port .I tried using that but didnt succeed.Let me know if you have better luck
 

feko koaxial feed

hey i just figured out how to give a coaxial feed.
First delete any existing meshing, voltage source and port on the CADFEKO.Mesh the geometry and save the file.
Then switch to EDIT FEKO , add the A4 control card.
- select set source and specify your co-ordinates for the probe location
-check the transform impedance to ground plane
The other settings are pretty straight forward.

Hope this helps.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top