# How to invert 12V Dc car battery to 230V Ac ?

1. ## How to invert 12V Dc car battery to 230V Ac ?

How to invert car battery 12V Dc to 230V Ac

•

2. ## Re: Inverters

By a simple push-pull topology circuit with transformer.

+++

•

3. ## Inverters

goto walmart and buy a 50\$ inverter!

Mr.Cool

•

4. ## Re: Inverters

you would have to design an oscillator and then use transformer to step up the output,,,

5. ## Re: Inverters

first of all to convert 12V to 230V the amperage should be high enough..
Although it is 12V it should be about like 5 to 10 A.

Now use a chopper circuit to convert DC to Intermittent square wave of 50 Hz/60 Hz.

Then you can use a square to sine wave converter to smooth-up your output for a perfect phase lag between V and I.

Later use a corresponding 50/60 Hz step up transformer to obtain required voltage.

•

6. ## Re: Inverters

Originally Posted by pnnavigator0915
first of all to convert 12V to 230V the amperage should be high enough..
Although it is 12V it should be about like 5 to 10 A.

Now use a chopper circuit to convert DC to Intermittent square wave of 50 Hz/60 Hz.

Then you can use a square to sine wave converter to smooth-up your output for a perfect phase lag between V and I.

Later use a corresponding 50/60 Hz step up transformer to obtain required voltage.
With this u can use the equation: V2/V1=N2/N1 to get no. of turns on transformer...

8. ## Re: Inverters

Originally Posted by nnm
How to invert car battery 12V Dc to 230V Ac
to make a cheap one get a 555 timer and configure it in an astable mode. for a better frequency stability generate about 100hz or 120hz and divide it by using a JK type or a Dtype flipflop to divide the it to two 50hz or 60hz two banks. then you will have to wave one inverted and the other not inverted. using transistor one or two for each bank usually an NPN (BC547 or SL 100) for amplification may be in darlignton mode or emitter follower. then for driving the transformer you will need two banks of power fets or transistors 2n3055 or TIP 142 or IRF250 (get their datasheet for their connection) connect collector or the drain of the power tansistors or fets to the transformer. the transformer should be of 12v -ov - 12v secondary side and primary 110 or 220v more or less power should depend on the load to serve and your judgement. experiment with this first and lets hear your feedback.

PLS IF YOU HAVE NO PRIOR KNOWLEDGE OF ELECTRICAL POWER PLS DONT ATTEMPT TO DO THIS HAS HIGH VOLTAGE IS INVOLVED. PUT SAFETY FIRST

--[[ ]]--