Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

A question of CDL out

Status
Not open for further replies.
H

hdqkwr

Newbie level 5
Joined
Jul 22, 2007
Messages
8
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,334
I get the foundry model of resistor has the following form:

.subckt subname n1 n2 l=length w=width
r1 n1 n2 ...
.ends subname

But in CDL out, I can only output the following form of subckt.
such as:

.subckt subname n1 n2
r1 n1 n2 ...
.ends

So I can't use my spice model directly,I have to modify my CDL out netlist to have the same form of my spice model.How can I get the CDL out subckt has the same form of my spice model?That is,get the CDL out scbckt has the width and length include in the first line of it.Or has other means to resolve it?
Thank you very much!
 

have you select the option when you run the program to get the cdl? There is an option about the output is R value or W/L

The worse is you modify by manual
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top