Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

area under the curve (average)

Status
Not open for further replies.
F

faizalism

Member level 4
Joined
Feb 3, 2006
Messages
78
Helped
4
Reputation
8
Reaction score
4
Trophy points
1,288
Activity points
1,850
I did digital phase detector for my CDR project. So, I need to calculate area under the curve for analyse it. There is any command for calculate this area (average)?.For your information, my phase detector output is not in rectangular form. I am using Mentor Graphic for simulation. Thanks
 

I think there is no command to calculate area under the curve..
You can get the binary value of the curve and change it to decimal which gives you magnitude.. and between two time scale get the magnitude and average it.. thats better...


Regards
Shankar
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top