Sezi
Junior Member level 2
Hello,
I want to make a post-layout simulation in Calibre. At the moment I'm extracting the layout with CalibreXRC and looking at the report and placing the parasitic capacitances in the schematic view and simulating. But it takes a long time and I know that this is much simpler with Diva, because within Spectre, the circuit can be simulated with its "extracted view" by adding in the Setup>Environment menu in Analog Design Environment window. So is there a simpler way to make post-layout simulations in Calibre?
Thanks!
Sezi
I want to make a post-layout simulation in Calibre. At the moment I'm extracting the layout with CalibreXRC and looking at the report and placing the parasitic capacitances in the schematic view and simulating. But it takes a long time and I know that this is much simpler with Diva, because within Spectre, the circuit can be simulated with its "extracted view" by adding in the Setup>Environment menu in Analog Design Environment window. So is there a simpler way to make post-layout simulations in Calibre?
Thanks!
Sezi