Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

placements of pads and padring

Status
Not open for further replies.
A

AsharAliQureshi

Newbie level 2
Joined
Jul 23, 2017
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
15
Hi,
I am facing a problem regarding adding padring
when I run sroute selecting padring its shows small connection between pads and spacers/fillers like jumper connections i think the connections should not shown kindly help me out

to my limited knowledge these connection should made internally and not to show like this

i have also attached link of the picture of the issue
https://obrazki.elektroda.pl/8019729600_1507530124.png
thank you.
 

Attachments

  • Capture.PNG
    Capture.PNG
    14.2 KB · Views: 58

Most pads should connect by abutment, no additional routing required. You have to set these nets as skip_routing/dont_route in your tool.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top