AsharAliQureshi
Newbie level 2
Hi,
I am facing a problem regarding adding padring
when I run sroute selecting padring its shows small connection between pads and spacers/fillers like jumper connections i think the connections should not shown kindly help me out
to my limited knowledge these connection should made internally and not to show like this
i have also attached link of the picture of the issue
https://obrazki.elektroda.pl/8019729600_1507530124.png
thank you.
I am facing a problem regarding adding padring
when I run sroute selecting padring its shows small connection between pads and spacers/fillers like jumper connections i think the connections should not shown kindly help me out
to my limited knowledge these connection should made internally and not to show like this
i have also attached link of the picture of the issue
https://obrazki.elektroda.pl/8019729600_1507530124.png
thank you.