Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

[SOLVED] Chip enable program error - At89s52

Status
Not open for further replies.

imkashi

Newbie level 1
Joined
Jul 22, 2017
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
8
Hi All,
I think i could solve this error "Chip enable program error"
if you were to use At89s52 micro controller along with serial programmer

You might need to just keep your Reset button onhold and then try flashing the code
you should not then see this error
Im just analysing why RESET hold will make disappear this error

Will keep posting..
Thanks ..bye :)
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top