kelvint
Newbie level 4
Hi
I am new for SKILL. I would like to create a new pcell from scratch (layout, symbol) and make sure it pass LVS. I use SKILL to create symbol, CDF parameter and layout. In layout, I use the following to define the terminal.
net = dbCreateNet( pcCellView "n1")
trm = dbCreateTerm( net "n1" "inputOutput")
pin = dbCreatePin( net fig1 "n1")
pin~>accessDir '( "left" "right" "top" "bottom")
When I run LVS, I get empty net in layout. What else do I need to setup? Do I need to write LVS rule? Is there any reference material on it? Thanks!
Kelvin
I am new for SKILL. I would like to create a new pcell from scratch (layout, symbol) and make sure it pass LVS. I use SKILL to create symbol, CDF parameter and layout. In layout, I use the following to define the terminal.
net = dbCreateNet( pcCellView "n1")
trm = dbCreateTerm( net "n1" "inputOutput")
pin = dbCreatePin( net fig1 "n1")
pin~>accessDir '( "left" "right" "top" "bottom")
When I run LVS, I get empty net in layout. What else do I need to setup? Do I need to write LVS rule? Is there any reference material on it? Thanks!
Kelvin
