akhilfrancis
Junior Member level 2
Hi,
Currently i am working on an autoclave device.
In that I have three major stages
1. Pre-vacuum
2. Sterilization
3. Post Vacuum / Drying/ cooling
For getting Steam I am using Heater and Water.
Next I am, coming to point.
I will explain the process.
1. I have to insert vacuum for removing the air
2. Then pouring the water
3. Heating until the inside temperature reaching the set point.
4. Then cooling
Here my doubt is After inserting the vacuum can I pour the water into chamber, because I am confusing about density relation between these two?
Or should I maintain separate reservoir for the water?
Thanks in Advance
Akhil Francis
Currently i am working on an autoclave device.
In that I have three major stages
1. Pre-vacuum
2. Sterilization
3. Post Vacuum / Drying/ cooling
For getting Steam I am using Heater and Water.
Next I am, coming to point.
I will explain the process.
1. I have to insert vacuum for removing the air
2. Then pouring the water
3. Heating until the inside temperature reaching the set point.
4. Then cooling
Here my doubt is After inserting the vacuum can I pour the water into chamber, because I am confusing about density relation between these two?
Or should I maintain separate reservoir for the water?
Thanks in Advance
Akhil Francis