mw_rookie
Member level 2
I want to use a pair of LVDS line to drive a single ended control line. The control line is used just to enable/disable an IC.
Enable is when driven above 2V, ideally 3.3 V.
I understand that LVDS has a current output and also needs a DC termination in this case. I was thinking of parallel termination and have come up with the scheme in the picture. Will this work?
View attachment Temp.png
Thank you for reading.
Enable is when driven above 2V, ideally 3.3 V.
I understand that LVDS has a current output and also needs a DC termination in this case. I was thinking of parallel termination and have come up with the scheme in the picture. Will this work?
View attachment Temp.png
Thank you for reading.