ElecDesigner
Member level 5
Hi,
Does anyone have an opinion on why C19 is present in the attached DCM flyback schematic.
Its a bit from this TI demo board.
https://www.ti.com/lit/an/snva465a/snva465a.pdf
I was thinking its just a snubber but why do that instead of an RCD snubber. Surely its going to be more lossy?
Unless its for some parellel resonance effect?
Does anyone have an opinion on why C19 is present in the attached DCM flyback schematic.
Its a bit from this TI demo board.
https://www.ti.com/lit/an/snva465a/snva465a.pdf
I was thinking its just a snubber but why do that instead of an RCD snubber. Surely its going to be more lossy?
Unless its for some parellel resonance effect?
Last edited by a moderator: