doors666
Junior Member level 1
i was trying to do a simple voltage follower but I am seeing a very high offset voltage, about 1.8-2v. I am using a 12v-gnd supply. I used a 10k feedback resistor and grounded the non-inverting end.
Even when i apply a signal to +ve terminal that varies from say 0-5v, I get steady 2v output till my input also reaches 2v. after that the output follows the inputs.
how do i fix these issues.
Even when i apply a signal to +ve terminal that varies from say 0-5v, I get steady 2v output till my input also reaches 2v. after that the output follows the inputs.
how do i fix these issues.