Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I did not understand this.... can you explain again what is the requirement.... how do you do this in real mobile???? Are you talking of conference call??????
---------- Post added at 16:29 ---------- Previous post was at 16:13 ----------
AT+CHLD Call hold and multiparty... is it what you need.....
Hi, here below is the explanation.
For calling one mobile number the AT command is as followed.
ATD12345678;
But what is the command for calling two or three numbers?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.