Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

How to send a step function for step motor through PCI-6023e

Status
Not open for further replies.

mohsenzh

Newbie level 3
Joined
May 18, 2004
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
15
data acquisition cards

how to send a step function for a step motor from MATLAB through a data acquisition card(pci-6023e) ?
 

Re: data acquisition cards

just address the right output port to which you have connected your whatever device and then send the data to the corresponding memory location or output register and then send command....its given in the data sheet
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top