Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi
You can use AD7730 IC from @nalog devices to condition the low level strain signals and interface this chip with spi interface with any micro like as pic ,8051,avr.
I used AD7730 ,and worked nice for me.But I do offer other AD77 members ,always I had problems with them in noisy and industerial environments.
745 SEN
Sensor Instrumentation Design Approach Abstract:
Designing a precision signal conditioning circuit can be tricky if all areas of the design are not taken into consideration. In this class,a precision load-cell will be used as the signal source, with a full scale output of less than 10mV. An instrumentation amplifier consisting of discrete resistors and op-amps will be used as the signal conditioning circuit, and a stand alone 12-bit A/D converter will perform the data acquisition. Filtering and voltage reference tradeoffs will also be discussed. Each student will then program a PIC18F252 using the ICD2 to show a working system, displaying individual results on an LCD display.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.