Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

comparator for sigma delta ADC

Status
Not open for further replies.
S

sandhaajith

Junior Member level 1
Joined
Aug 22, 2008
Messages
18
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,381
i designed a comparator for a sigma delta ADC and it is working fine.But i need to give the output to a latch through an inverter.after connecting a D latch to one of the outputs, the output changes.If latch is connected to both outputs, the circuit works fine.Can anyone help
 

It is difficult to tell from your description, but I would guess that there is a load influence on the comparator, or more specifically an influence of mismatch of the load. This can be often found in a latch type comparator. If your comparator is this sensitive to mismatch in load, it must be either redesigned, or you must be very very careful in layout. There also may be a large influence on component matching if you see this much load influence, so be careful of this too.
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top