Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to make co-simulation optimization effictively in ADS?

Status
Not open for further replies.
J

John_li

Full Member level 5
Joined
Aug 6, 2005
Messages
272
Helped
9
Reputation
18
Reaction score
1
Trophy points
1,298
Activity points
2,945
ads simulation optimization

Hi all,
I designed wilkinson divider using ADS.I have run optimization,and get the result that i want(current EF=0) in schematics.But when i did co-simulation,the result can not meet the specification.What should i do in the next step?Because the optimization of schematics is OK.
 

Have you placed compleate transmission line with 5 port in layout? then export to layout look like after parametrization. Place the 100 Ohm resister. Then optimize.
I am sure that you will get zero error function.
 

    J

    John_li

    Points: 2
    Helpful Answer Positive Rating
Yes.I placed 3 ports in input and output termimals,and the other two ports to isolation resistor.and export to look alike.I do not know whether ADS has optimization funtion of microstrip in co-simulation?
Another question,whether can i add a resistor in layout,and directly tune the microstrip before Co-simulation?Can you tell me how to add it in detail?
Thanks
 

Re: How to make co-simulation optimization effictively in AD

Another question,whether can i add a resistor in layout,and directly tune the micro strip before Co-simulation?Can you tell me how to add it in detail?
Click to expand...
Lumped resistor can not be placed in Layout. You can place the discrete component having W*L*H and you know the resistivity etc. its a long process so recomend to use schematic.
I do not know whether ADS has optimization function of micro strip in co-simulation?
Click to expand...
Do you know parametrization in Layout? if not go through the help.
You need to parametrize the 75 ohm length and width to get EF=0. If you export to schematic with layout look like then you will find these parameters in the schematic component.
 

    J

    John_li

    Points: 2
    Helpful Answer Positive Rating
Dear Kspalla,
Thanks for your reply.The first time using parametrization in Layout,and i use ADS2008 online help.I try to find some documents about parametrization.unfortunately,i can not find none.I do not know how to find the subject.Can you help me generate the subject into PDF format,and send it to me:John_li3000@sohu.com?
Thanks,
John
 

You can get the detailed help from the installed folder C:\ADS2008\doc\mom\ads2008\Layout_Components_for_Momentum.html if it installed in C drive.
Let me know if you still has problem.
 

    J

    John_li

    Points: 2
    Helpful Answer Positive Rating
Thanks,kspalla!I find it.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top