Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hey guys... i am looking to design a comb genr .. who can help me with an elementary circuit or give me a heads up on the devices which will be needed.. im looking to work in the 100 Mhz range. pl help . thx..
tht is correct the VCO will give it the input frequency ... but u see the comb pattern is seen after the FFT of an impulse generated, this i plan to achieve by using a step recovery diode... i read the HP application notes available.. but then i dont see which step recovery diode to use and hw will the circuit actually look like.. so was also thinking of looking on the lines of sfwre implemtation done using MATLAB.... also hw to use a band pass filter to get almost unifirm power distr thru out the comb pattern.... so further help will be appreciated.. thx..
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
