Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Very begginer question about wireing

Status
Not open for further replies.
Hi matt,

the wiring says that wires 1 and 3 are connected, and wire 2 is not connected on neither wire 1 and 3. see this figure below (Hope this helped you very much and dont forget to push the "helped me" button huh)
 

    M

    Matt17

    Points: 2
    Helpful Answer Positive Rating
Thank you for this drawings and expl. !
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top