Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How could I estimate the noise profile of OTA?

Status
Not open for further replies.
safwatonline

safwatonline

Advanced Member level 4
Joined
Nov 19, 2005
Messages
1,341
Helped
219
Reputation
438
Reaction score
48
Trophy points
1,328
Location
EGYPT
Activity points
9,038
hello,
i want to know how could i estimate the noise profile of a circuit say an OTA.
as i have done noise simulation but i cannot decide wether the results are good or not , i dont even know what to expect.
thnx

plz keep it simple, i want only basics.
 

Re: noise

u can show the contribution of each device in the output noise from spectre.

From the results menu choose print --> noise summary and adjust the seetings u want
 

    safwatonline

    safwatonline

    Points: 2
    Helpful Answer Positive Rating
noise

i want theory not simulation , i.e. how to expect the profile before simulation , as i get the profile but it means absolutly nothing to me
 

noise

suggestion:you can do some hand calculation for the input-referred noise,and compare with the results of inoise
 

Re: noise

For an OTA, you would expect a classical noise profile:

1/f noise at low frwquency then a thermal noise floor at higher frequencies.

Concerning the values, it is hard to estimate noise by hand. However, hand analysis would be necessary to see which devices contribute more noise to the i/p. This can be done simulation too as eng_semi pointed out
 

    safwatonline

    safwatonline

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top