Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to use power switch

Status
Not open for further replies.
S

strahd_von_zarovich

Advanced Member level 4
Joined
Sep 25, 2015
Messages
118
Helped
1
Reputation
2
Reaction score
3
Trophy points
1,298
Activity points
2,463
Hi, I am trying to figure out how to use this power switch :
switch1.JPG

Which connections should be made to illuminate led only if i turn the switch on and of course provides electricity to my load.
 

Hi,

Each device has a datasheet.
Find out it'smanufacturer and type name, then download the datasheet and read it.

Klaus
 

Hi,

So it has 9 terminals.

Power entry a the bottom: 3 terminals marked with "L", "N", and Eerth ground.
Fuse at the center: 2 terminals
Switch at the top: 4 terminals of an DPST switch. One pole left, one pole right.

Where do you have difficulties?

Klaus
 

Better to by inbuilt LED switch as below link
https://www.digikey.com/product-search/en?mpart=4304.6071&vendor=486

Insert a fuse (based on the current rating) solder the output wire (1 line wire , 1 neutral wire , 1 earth ground wire) earth wire probably attached to chassis.

Keep in mind that line terminal will go to fuse then switch and neutral terminal directly go to switch (you can use switch outputs line and neutral for your application)

Please take a multi meter and conform if you have further doupt
 

Thanks everybody for help.

It is a simple series circuit then. High voltage scares me a little. Sorry for wasting your time.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top