Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[PIC] debuging and simulation

Status
Not open for further replies.
S

spartekus

Member level 5
Joined
May 27, 2010
Messages
81
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Location
Duisburg, Germany
Activity points
1,918
Hi, i didnt know how to search about this. i hope it is not asked before.

1 - i have a circuit with microcontoller.
is it possible to see changing of variables in mplab ide when i turn potantiometer?
in other word, can mplab ide read changing of variables from microcontoller? Thanks

2- Which program would u suggest , to make circuit simulation which has microcontroller in it? thank you.
Regards
 

2) For simulation
you can use proteus-isis (isis for schematic, isis is half part of the proteus program)
there are so many pics in the isis,
you can load your hex or cof file
(which mplab produced) to the pic in the isis schematic,
when you loaded cof file you can run the code
step by step and visualize all the registers and pins,
also you can added so many peripherals,
you can added leds, 7 segs, lcds, other chips,
ports like virtual uart and virtual usb
and communicate with your pc as if
your circuit in the isis connected to the com or usb port of the pc.
 

Thanks for answers,

brunofunchas, do i need any special device or kable for JTAG, or ICD 3 have jtag inside?
would u suggest me any tutorial about it, (with Mplab IDE).
 
Last edited:

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top