Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Dear All,
I need information how to simulate S-parameter LCP and RCP in cst too. Should I use either floquet port or plane wave excitation? However, how I can calculate S-Parameter LCP and RCP because by default CST just calculates the S-11 or S-12 ... Thanks in advance.
Regards
Dear all
I would like to convert a picture in png file, from CST, but it just supports for BMP. Is there another alternative to get better quality picture. Sorry for the simple question. Thanks in advance
regard
launching the wave in rectangular waveguide
Dear all,
Can someone explain about the diference betwen cylinder wave guide and rectangular wave guide , when both are implemented or simulated. I mean the advantage and disadvantage.
Thanks in advance
Dear all,
Could anyone has experience using cst explain me , how to make magnetic and electric wall in such a case.
I make single patch and want to investigate infinite sequence array by using mirror concept.
Put E wall in front of it and behind it, and H wall on the right side and left...
Dear all,
can anyone tell me about how to simulate SMD in CST and momentum , I want to connect microstrip and smd , both in momentum simulation and CST. Is it enough just use lumped element of CST ?
thank you in advance
sma connector ads
Dear all,
I would like to design patch antenna with SMA connector from the ground plane.
How can we simulate the SMA connector using momentum?
Btw. it is could be understood using HFSS or CST.
Thanks in advance
I simulated S-Parameter of many patch arrays using momentum than had a problem with time processing and memory. The process stopped because it was not enough memory (the memory is 1.5 G), If I reduced the mesh number, there was a warning which said my simulation would not be accurate.
Is...
It's about designing microstrip array with ADS
Instead of using Full wave analysis, we can use Transmission line for microstrip array. Anyone can explain how to investigate the effect of mutual coupling of the patches using TL analysis for microstrip array , which kind of component should be...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
