Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi Guys,
I am working on a project that require me to develop a device which will scan limited spectrum detect GSM, WCDMA or LTE signal and then record the signal strengh, pilot number and signal quality. Any suggession?
Dear Users,
I am looking for any kind of help regarding any VHDL programming of GSM CDMA WCDMA LTE HSPA WiMAX. I am working on a project where we have to develop a chip which will work in all protocols.
Many Thanks
I am a MS student. My professor asked for a wired assingment.
The question is following:
What are the options for resistors in 180 nm CMOS process?
If any1 have any Idea please let me know. I would appriciete the help.
Still I need to know how to use the C code that I wrote in a Spartan 3E board. I need to know how I can get some sort of software that will do that for me.
I need to know all about Micro Blaze and how to use it.
Please let me know if there is any free software for Micro Blaze??
Does XIlinks IDE have any built in Micro Blaze software???
If I have to use another software what is it and how much is the price???
I know the microblaze soft process...
lcd interfacing vhdl code
Thank You soo much for the veryog code.
My code actually puts an A in the LCD display. Well that is actually what it suppose to do. But it is not working. Yes I am using UCF.
I followed the user guied timing. I think your way is much better as it insure everything. I...
vhdl code for lcd interfacing
Dear Echo47,
SOrry for my short message. I am a FPGA passinate FPGA desighner. I am trying to use the LCD display for the Spartan 3E Starter Board. I did not find any example or any material how to use it. I have the user guide and the example of the preloaded...
spartan 3 lcd vhdl
I need help too with spartan 3 started board. Problem is I want to use a VHDL block not a picoblaze. I can do wat ever with a pico blaze but not with VHDL.
Well when I simulate it in the modle sim it shows the right wave forms for the intialization then writing of the letter. But it does not work in the board it self.
the code in is below for programming the LCD to display using the spartan 3E instead of the pico blaze :
library IEEE;
use IEEE.STD_LOGIC_1164.ALL;
use IEEE.STD_LOGIC_ARITH.ALL;
use IEEE.STD_LOGIC_UNSIGNED.ALL;
entity LCD is
port(
LCD_RS:out std_logic;
LCD_RW:out std_logic...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.