Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Any circuit dealing with intermediate voltages other than high and low.
Combination of above with few digital logic can also be termed as mixed signal.
SerDes, PLL etc.
as of me there are two ways of which i have tried one.
1 - select each and every polygon see its properties and change the x & y co-ordinates.
2 - write a skill file to check the grid of all geometries present compare it with the actual grid required if not plact it to the nearest correct grid...
the metal width design iis according to the current carrying capability of the particular metal/micro meter.
caluculate according to it.
for this value refer to the design document
off grid error
it refers to the resolution at the manufacturing equipment at the fab.
it varies from fab to fab and pdk to pdk.
before starting the layout u need to do some initial settings change in the option DISPLAY and save it.
if u get an off grid error just write a small script to...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
