Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
ya, for IC's i can see the datasheets. But I wanted to design a TDC of my own, say a simple vernier delay line TDC. Based on what should I fix the limit of my input rise time
1596200678
yes, how much should it be fast, timing uncertainity i get it.
I wanted to measure jitter (by simulation) for my 10KHz oscillator. Can I run a PN analysis using spectre and integrate it to find jitter?
Why there are no Phase noise plots for low frequency oscillators and how are their jitter characterised in general?
Hi, I am referring to a thesis from niknejad's group, which uses the following formulae to convert phase noise to frequency uncertainity
I tried calculating frequency uncertainty for the same example that was stated in the image. But I could not get the 0.1 ppm answer that he gets. can someone...
Re: TDC IC start and stop
Yes i understand that it gives the time period between start and stop. But I have only one digital signal as input , whose frequency is to be counted. What will my stop input be? (eg. TDC7200)
Hi, I wanted to measure the frequency of a signal using a TDC. Typical TDC's uses a start and stop signal as input. What does that mean and how does that help me in measuring the frequency of my signal
hi i asked which is better of the two (i) LR time constant (ii) resonant frequency, in terms of accuracy.
- - - Updated - - -
hi smijesh, i asked which is better of the two (i) LR time constant (ii) resonant frequency, in terms of accuracy.
Hi,
I have come across unknown inductance measurement by
(i) connecting a resistance in series with the inductance, thereby measuring the time constant, from which the inductance value is calculated
(ii) By using a resonant circuit, from the resonant frequency.
Which way of measuring gives a...
Hi, I have designed the cascode BGR attached in the fgure. When I connected n AC source and measured the PSRR i get only around -15dB at 1KHZ. pls tell me why i get very low PSRR.
- - - Updated - - -
Image attached
In a mixer (gilbert cell), whether the diff pairs acts as a current/voltage switch? What are the properties to find out if a mosfet acts as a votage/current switch?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
