Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hi every body,
i designed a transcondutor in cadence msfb .
After i designing the transconductor , i try to make the
simulation and to analysis the gm characteristic of the transconductor.
As we know Gm=Iout/Vid , however i cannot get the curve for gm coz i cannt
select Iout in the schematic...
thanks for your reply,mpig09
for a given PWM signal , 0 and 1 are presented with short pulse and wide pulse respectively.
then i need to design a cmos recevier circuit which is utilized to distinguish width difference and extract the data and clock.
so i think may be a CDR cirtuit is needed ...
hi everyone, im a new fish in analog field form sweden.
these is a project for me rightnow to desgin a CMOS discriminator circuit for data and clock recovery of the PWM signal.
However i don't know much about it . So can some nice guys give me some hints or recommend some valuable materials...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
