Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
i1 i2 o/p
========
0 0 0
0 1 X
1 0 X
1 1 1
this is my requirement.
- - - Updated - - -
with "AND" gate, for the inputs 0 and 1, 1 and 0 output is 0. but i need the previous output as the present output for those inputs.
hi there,
there are two logic inputs i1 and i2. when both are 0 the output should be 0. and when both are 1, the output should be 1. in other conditions like 0 1 and 1 0, the previous state should be the output(dont care conditions). please help me with formula.
but in 74ls373, once the latch enable signal goes low, the output is not changing in any case even the clk is fed high again. only way to reset it by reseting the ic completly.
hello,
as my understanding on d latch, if clk is high, the d input will result in the output. and when clk goes low, the output is latched. and again if the clk goes high, then d input reflects at the output. but in the case of 74ls373 latch ic, when the clk goes low once, the out is latched for...
hello,
in 8085 microprocessor, accumulator is used to hold data as well as shifting. as it is a register, how it can shift data. also in 8086 cx register is additionally used to increment. how it is possible?.
and one more doubt is, as rd, wr, Io/m signals are available, why the...
when I was trying to find answer for the following question, I got the answer 1022. please help me with your answers also.
find how many times the two JNZ are executed?
LXI H, 0503h
DCR L. : LOOP
JNZ LOOP
DCR H
JNZ LOOP
HLT
:roll:
hi there,
let us take 8085 register A value is 00h, if we decrement it by 1 continuously, carry flag will set and A register value decreases from FF to 00h. even if we decrement, what will happen. please help.
thanks, if both vss and vdd are connected to seperate output transistor, then what is the problem when both are turned on together.
and also why they have different current carrying capacity in two directions.?
sorry rohit.
I googled but I couldnt get clearly. tats y I asked. anyway thanks.
- - - Updated - - -
how a conductor can source and sink different current. for ex. 8085 microprocessor buses can source 400microamps and sink 2milliamps of current.
suggest me some books and resourses to study deeply about microprocessors architecture and programming. Especially for 8085 and 8086.
thanks in advance..
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.