Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
help me in desing of AC filter
which placed after the LISN
problem:getting harmonics from suply section whichis more than the required level.
Aim:to supress the harmonic levels.
site:www.edaboard.com quater
Plz provide properties of quater wavelength transmission line.How it is used as a impedance transformer?plz provide clear details.
www.wikipedia.org/wilkinson_power_divider
plz help me .
what are the calculations for single stage power divider and multistage powerdivider for Wilkinson powerdivder.plz send formula.
thanks®ards
vamshikrishna
Re: Wilkinson on FR4
Hi
u can design powerdivider in ADS simulator.
use sub 5880 ,31 mil to get better results.
1). use two 70.7 ohms in parlell and one isolated resistor of 100 ohms.
Dear sir,
I need to design VCA of freq 5.4 to 6.0 GHz by using PIN Diode.Any simulators are there to design for this type of circuits.
thanks and regards'
vamshikrishna
Re: vco design
i want to design vco in discrete level because of high cost of vco at higher frequency.thanks for u r reply.
Added after 4 minutes:
thanks for sending link and also i am designing c-band VCO can u help me in design point of view.my frequency of interest 5400-6000MHz.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
