Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
yes i know it how can i set my PA on class A for exp.in other word where and how should i place the bias point on ID-VDS curve that make the transistor work on class A?
what is the location of bias point on ID_VDS curve exactly ?
thanks.
i am beginning. how can i place load and bias resistor? in this circuit how can set load resistor , ... to determine bias point to make for example A class power amp .
thanks
hi.
i am decided to design power amp. but i don't know how can i determine the bias point from ID-VDS curve ,is there good document that explain design of dc biasing of PA ? my schematic and my curve is attached.
thanks.
hi every body.
i am beginning in microwave design .i decided to design class AB power amp in ADS . but i don't know how can i make dc biasing to achieve class AB power amp in ads.
is there any body that help me with step by step instruction of design class AB power amp
specially dc biasing of...
hi every body.
i am seeking for image processing libraries such as rgbtograyscale library and matrix library and ...
is there any body that can help me???
thanks.
hi.
i have imx53 and i decided to connect ov3640 cmos sensor(www.jmtsz.com/upLoad/down/month.../201203071208009202.pdf) by it in csi interface.
but i have problem in schemetic .
is there anybody that has schematic of it?
hi.
i have inanbo t28-ili9320-v11 tft that it's controller is ili9320 and work by parallel interfaceby data sheet of :www.inanbo.com/downfile/tft/28/INANBO-T28-ILI9320-V11.pdf.
i am going to config it by raspberry.and i used spi to parallel converter that circuit is...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.