Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
how many address lines ?
I got one doubt regarding bus interface .
A peripheral of 512 Mbits has 16 bit data bus width.
I need to calculate the total number of address lines of the peripheral.
If it is 512 Mbyte and 16 bit databus width then ,as per my understanding the total number of...
Re: skew
What I feel is set up and hold time parameters have a dependency on skew value also.Skew changes will affect the set up and hold time.Youe have said there is no violation of hold and set up time requirements which implies that skew value is not causing any problem.
But the marginality...
Re: Overshoot
Thanks for the suggestion.:D
But this is found in the product which is under use.So we cant go for any external changes.In this case how can we predict the reliability of the device used on the board?
1.Will the device work with this scenario?If so how long will it work ?How to...
I need to know whether the following scenario will affect the my device :|
One input pin of the device receives a clock signal.The absolute maximum allowable overshoot at the pin was given as 5 V.The supply voltage is 4.3V .But while taking the signal quality capture a discrepancy is...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
