Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Is the connection between wireless devices depends on both devices range or only one (the higher or lower)
for example i have a router with range 1km and a laptop with newtwork card 150m
Is the range of wifi connection (the range i can connect to the router) depends on the range of router (1...
hi,,
i was wondering what would happen if i ran a microcontroller with a frequency higher than it's max frequency for example running atmega on more than 20 Mhz,
will be a problem in functionality or just will consume more power?
and what is my limitations of the max frequency , bandwidth of...
HI,
I know that this may be a silly question but i am new at computer architecture.
This image is for a single cycle MIPS processor i see that it has a data memory and instruction memory, do that it is harvard architecture ; because i read on the internet that mips is von neumann,
it's confusing.
hi,,
i am using a sensor-ir- in wall following and i need to count the walls i face so i connected the forward sensor to comparator then to counter(74191) but the counter counts more than one pulse -even when i move a paper accurately-,so i need a way to remove these noise
thanks.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
