Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I am looking for a heat sink that suits to bridge package like KBU810.
Importand is that the heat sink sould have a hole in order to fix it on the bridge and
a small size.
My Kind Regards
Thanks BUS MASTER but there is a special need for Op-Amp since PSOC and
other mixed mode MCUs are fare away from implementing accurate projects.
I am aware of PSOC since I have done a couple of projects.
My best regards
I have an intercom that works through mains.
My problem is that the two appartments I want to communicate are supplied from different phases. One from R and the other from S. What can I do in order to communicate between the two appartments via intercom ?
Note I've heard that one solution is...
I look for information concerning biotechnology reading of palm. The idea
is to have a sensor that reads our hand instead of our fingerprint.
Does this sound good or is it out of question ?
My regards
temperature vs humidity
Is it possible for Humidity to interfere with temperature and give false results ?
If so what is the method to measure temperature only ?
My regards
There are some burglar alarm systems they utilize a presure sensor to detect
rush movements of doors-windows etc.
Has anybody such a background to enlight us ?
My regards
rtc chip
Dear IanP
I use PIC18F242 to control the RTC chip. Note that RTC chip is backuped with a
3V lithium cell.
I program the time into the RTC via MPU. After this I disconnect the I2C bus.
In this status I cut off the power and give it back again some times. Now I connect again the...
pcf8563 example
I have made a design where I supply my MPU and rest of circuit with 230VAC via
a Capacitor. All logic is supplied with a regulator with 3V.
I experience the following problem. When the power supply cuts off and then
restores the rtc chipo looses 10 minutes or gains 10 minutes...
site:edaboard.com +hands free
Maybe someone has involve and knows something about my issue.
I need an one chip solution for a telephone dialer with hands free capability
that has a low cost as well.
I know all ready some chips from Austria Micro Systems but they are quite expensive.
Perhaps...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
