Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
USB as OTG(for keyboard)and HOST(for pendrive)
Hi, we are using freescale kinetis microcontroller k60DN 512z and code warrior 10.4 with processor expert for connecting pendrive in USB port USB0. For that we used USB LDD component and set as host.
But when we create fsl USB stack for keyboard...
hi,
i have purchased one gsm module with sim 900A, power supply section, uart, antenna, sim card holder etc.
**broken link removed**
**broken link removed**
when i connect power supply to module, my newtwork led is blinking. and i can make a call to this number.that means sim 900a is...
hi,
In our project we are using 18f4620 controller, ccs compiler 4.119, 3 common cathode 7segment displays, modbus(rs 485).
If we are not using modbus, the 7segment is working properly. If we add code for modbus and read the holding registers, the display is blinking. ie, if modbus code is...
Hi..
I have a problem in hyperterminal.. please help me..
When I click Start->All Programs->Accessories->communications, Hyperterminal is empty.i cant open.
in start menu, run. When I enter hypertrm , hyperterminal was opened.but I couldn’t configure the PORT.there is only one option in...
thank you ...
i found USB to Serial TTL Converter with CP2102 while browsing. but it has male connector.so i cant connect pendrive with this.
can i use cp2102 ic for interfacing controller and usb female connector?
Hi,
in our project, we are using 18f4620 controller.some information is saved in external eprom connected to this controller. i want to connect one pendrive (usb) to my board for collecting those data saved. (later, pendrive is connected to pc for display)
for that i have to interface one usb...
hi,
in our project , we are using 11 rf id transmitter. and one main unit with rf receiver.
now we wanna integrate cameras for each transmitter.
ie, if one transmitter transmit one id, corresponding camera should be on.is there any camera available which detects rf signal??
hi,
we decided ti use C202 CDMA modem (simware model) with p89lv51.but unfortunately i didnt get the data sheet for that model.ie, we didnt get the AT commands for that modem.Can any one help us for getting AT commands.from which link should we search? i tried.but didnt get for this model...
hi,
we interface gsm with 8051.now going to inteface with cdma module.can u please suggest one cdma module for interfacing with 8051.i saw huawei E
M660 module.is it ok for communication?
we prefer 400/800MHz freq
please suggest me one cdma module...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.