Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I need a pulse voltage source that slowly gets narrower as the simulation progresses. How do I create a dependent pulse source that used a ramping voltage, or some other input, to adjust the width each time the pulse is high? I'd like the period to remain fixed.
Alternately, if I could tell it...
Hi Dilma,
Take a look at Microchip's USART ap note AN774. AT commands are text and you can send them through the PIC's serial port just like you would with a terminal emulator.
Good luck, Chris
Just about any general purpose Flash micro will do this. What is important to you? Price, familiararity, speed, power? These and other things must be weighed when picking out a micro.
Re: how to start with iar
The beauty of IAR is that it has a very easy to use IDE that is consistant across platforms. Also, it comes with some very good examples that should get you going. Don't be afraid to call their customer support with specific questions. Also, the applications engineers...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
