Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
philips/fr951/diagram
FR951 D 1997-09-18 749 1599 CBT No or weak sound from one front channel "One of the metal holders of the main PCB could be short-circuited.
The short-circuit is near J563 and the audio line is coming from J566
and this fault only occurs in the second version of the PCB...
Hi, I also own a Philips FW41. I was using it for many years with my TV. The spatial sound function DOES work with AUX-TV. I think you should start checking for faulty resistors and caps following the AUX-TV audio signal traces on selector board and main board...
Hi, this fault is common in old TV sets. This may be caused by ripple in the power supply (around 200V) of RGB output circuit. Look for dried up caps around CRT neck. These caps are usually rated 4.7-10uF, 200V. Also check the small caps around FBT. Small caps are hard to check so use a...
philips dcc 900 service manual
Hi,
If ya need Philips DCC900 scheme, visit **broken link removed**
Added after 35 minutes:
Here is the Philips DC900 user's manual
Re: Service tip/ manual required for a Chineese made DVD pla
Hi,
First check the power supply board for other faults. Try measuring the voltage by giving some load (using 500-1K resistor). If the voltage seems to be ok then there is a fault with the rest of the system. I think the power...
Re: Philips FW40
Thanks for the file but I need schematic of the front board of FW40. This PDF contains all about power supply board. If anyone has schematic of the front board then please send it to me.
Check the charger if it gives the recommended ouput voltage which is usually given on the charger. Slight differences are ok. If the voltage is low then your charger if faulty. If the charger gives high voltage then both the charger and battery are faulty.
philips fw41 keine anzeige
Philips FW41 mini hi-fi is inoperative. No display on FTDs. Only volume & DBB LEDs are burning. Checked all the power supplies. Please help me to fix this fault.
- Thankyou
hi fi with 7 display
There is a 30V negative bias for the two display tubes. If the display is too dark or flickering check the 1000MF 10V capacitor for leakage. If the cap. is ok then check the BD236 transistor connected to a heat sink. Also, check the safety resistor near that transistor...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
