Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello All,
I need to design a 3.3V, 2.5V, 1.2V power supplies for my FPGA board. The 5V power has been taken from PC. For 3.3V and 2.5V, LM317 has been used. For 1.2V, LT1963 has been made use of. But the working environment for which this card generates I/O is very noisy generating 5kV/5kA...
Hello all,
I am developing PCI-FPGA control card. The card has to generate 48 digital outputs, 16 analog outputs and 16 timer outputs. Spartan3 FPGA XC3S400 has been programmed for digital and timer signals. The timer pulses are of 10 microsecond duration. For analog outputs, MAX505 (quad-dac...
Hello all,
Can someone share how to add a self test code on FPGA and how is that implemented together with hardware. I have also seen certain hex codes for 8051 kit self test. How BISt is achieved?
Thanking you in anticipation.
Regards,
Sonika
Hello all,
I am designing a PCI-FPGA board with PLX 9052 as the PCI compliant agent. The outputs that i m taking from PLX are local address n data bus with 5V/8mA capability and write signal with 5V/12mA drive strength. All these signals have been pulled up using 10K resistors. These outputs...
I have to make a project - PCI interfacing for some control applications. It is data aquisition type. as far as i know, it requires the developing of the window driver software for driving PCI controller IC. and programming is done in C but the functions will be called in LabVIEW which is used...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
