Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
program- mikrobasic- seven seg
Well sheth_ka I am attaching the Crownhill Proton IDE some of my fellows have used it and they found it good. I don't know whether its a full version or just an evaluation version you just check it up hope that it might help you i'll send you the schematic for...
Re: Advices are needed
Hello athen_karkanis!
Seadolphine_2000 is right.
If youre familiar with c language use mikroc its superb you can download a free version form various sites just google a little.
Good Luck!
dc motor interfacing using 8051 and transistor
Hello rksiwal!
Check if the gnd of the whole circuit is same or not
Last year i had to interface parallel port to 8051 and you know what i had done i just didnt connect the gnd of my 8051 to gnd of my db25 connector and when i connected the 2 the...
how to use interrupts in pic 16f877a
Well Sheth_ka!
Why don't you use the multiplexing technique its easy and you will have your number of pins reduced too at the moment you have got 16 pins connected to your 7 segemnts by using multiplexing you will have just 7 for 7 seg and 4 pins for...
picpgm problem
I think you're right its really a waste of time coz 2 or 3 months ago i made a programmer for pic16f877 it worked correctly for 2 or 3 times and then i couldnt understand what happened to it.
Thanks for your suggestions I'll definitely look for those things and then inform about...
Hello everyone!
I suggest that you should start your pic life with pic16f877. Get the book "Interfacing Pic Microcontrollers by Martin Bates". Go through the beginning 4 or 5 chapters and u'll feel yourself Master. Download the free version of MPLAB its the assembler environment both for...
Re: micr controller
Hello waq!
Which pic are u using? Ive got a counter program for pic16f877. If you want it just drop you email address and ill send it to you.
Good Luck!
Re: USER INTERFACE:1 enter/settings switch,2switches->2di
Hello Fantabulous68!
Last year i also faced the same problem while designing a 8051 based visitor counter in it i had to set the limit of te number of people entering the room by using two push buttons and the algorithm was the same that...
mikrobasic blink led
Hello Sheth_ka!
Well the type of application that you are designing requires the use of interrupts. For using three switches for start reset and pause you will have to use the 4 pins of port b <7:4> which are used as the port b change interrupt pins. Any change detected on...
microcontroller coding
Hello Deepak!
First of all check out www.8052.com its a wonderful site for beginners.
Tell me if you have an ATkeyboard connected to your 8052 or just a numeric keypad that is do you wish to display only numbers using a numeric keypad or letters as well as numbers using...
picpgm
Hello everyone!
I've a problem regarding the PICPgm programmer. I've built the LVISP Programmer. PICPgm detects the programmer but not the PIC. Ive tried two pics uptil now and they are PIC18f4550 and PIC16f877 but none could be detected. I've checked the connections again and there...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
