Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi guys!
I need a little help too.
I want to know which cell models support SMS TEXT mode ?
I know, lot of cell phones can operate in PDU mode, but I want to know the TEXT mode like t290 from Sony ericsson,
Please List as much as possible, Because I am not sure, Whether I'll be able to get any...
you provided a scematic of NPN's, but do i always have to use in Darlington form,
can i not use as single form, not in darlington configuration??
---------- Post added at 14:13 ---------- Previous post was at 14:09 ----------
and next
i got a L298n IC,
now any suggestions, from where should i...
understood that very well,
that's great.......
@@@@@@@@
now that was the real problem, i had,
after seeing the connections you made to motor, this came to my mind, and i composed a paint file to ask you the same thing , ( file is attached ), but now i had understood that..........
thank you...
yes boss!
it is tested and found working,
really thankfull to you......
i have just 2 more questions, 1st is that, what might be the reason that my circuit was not working?? after i have changed the circuit just like your's except the addition of resistors(resistors not installed) ??
although...
understood very well,
ok, this means, i have to generate some small delay, like some hundred cycles.....
thanks once again,
i'll reply in 2 hrs, after i make and check the working....
thanks
Sorry bro!
I mistakenly wrote "Collector" in place of "Emitter".
Please read my above post once again, as it is re-edited.
---------- Post added at 17:43 ---------- Previous post was at 17:39 ----------
I have already done that, but of no success...........
Which version of Proteus are...
Boss, i got your point of Current limiting resistors, and i had also a loook at your refered Links of H- bridges, but
as above you have mentioned that
"
" but when i take my voltages of emitter lower than the BASE, still it won't work,
I have also made the Motors operating voltage less,
Still...
hi to all,
help required in driving Bipolar stepper using uC in Proteus only,
i am assigned to drive a bipolar stepper motor in proteus simulator,
after reviewing much literature, i got to the point of designing, but still no success, as motor is not turning, the logic is working right,(as it is...
Thanks sir,
i am cleared on the point, I have checked the motor by giving pulses to its coils in specific sequence and it works as desired,
Now i just want to ask,
which switching transistors should i use for switching in motor??
I want to use discrete components, no ICs, So please list me some...
what do u mean by Dual H-Bridge??
do u mean that there are 2 poles so we need one H- Bridge for each Pole??
i was started on thinking like this because 4 transistors were required for a single H-Bridge like:
SEE the attached link........
Driving Bipolar Stepper Motors
and if there are 2...
i am trying to drive bipolar stepper motor, i have got no special bipolar stepper motor driver IC, instead i m using a Power supply which can give current upto 1A,
first of all, i found resistances between different terminals,
which found to be...
RED-------9.7 Ohm-----yellow
orange----9.7...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
