Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
two ways
1. put all the designs in the same directory and same project, then to compile and test.
2. instead of .bdf output, take .vqm file of the two design and put it in the design
this will always work.
regards,
baba
Dear all,
interview question, is it correct,
one bidirectional pin should connect to two bidirectional pin, is it correct, it breaks my head
regards
baba
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.