Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
moc3020 & triac circuit
Hi
can anyone give the complete schematic of triac and moc3020 along with the values of resistor to be put for lighting up a 230V AV from AVR microconttoller running at 3.1 V and can supply 15-20 ma at its port.
when i shorted pin 4 & 6 of moc and put 67K in between...
moc3020 triac
Hi pranam77 and everyone who replied to this topic.
I tried the following experiments and found the following results.
1) The schematic is same as layout
2) during forward bias the voltage across input diode is coming as 1.5-1.9V and in reverse bias the full voltage is appearing...
wireless sensor network simulation
HI
If any one has done any network layer simulation in Ptolemy by Berkeley.
Please provide me with the models.
I have found that i will have to make all the layers below network layers from scratch which would consume time unnecessarily.
Please help me...
moc3020 circuit
HI
I want to drive a 230V AC load from a triac whose gate is fired by MOC3020.
The circuit diagram is at
https://obrazki.elektroda.pl/21_1228334288.jpg
as per debugging done uptill now, I found that output of MOC3020 isn't able to drive the triac gate. Currently I am using...
Take some techfest problem statement and make it your FYP.
You can enjoy dual benefit of getting marks for it and maybe a prize.
visit www.axisvnit.com
or try www.techfest.org
bt136 circuit
Hi
In the given circuit, I am taking output from a microcontroller and load is a small electric bulb , 230 V , 50 Hz.
Please see the circuit diagram below and the test results and help me with the debugging
Circuit Diagram is
https://obrazki.elektroda.pl/21_1228334288.jpg...
pcb designing part time jobs
Hi
I am intersted in the above job. I have a good experience in this field.
Can you send me the details at sharadbags@yahoo.co.in
yes, I am also keeping an option for connecting RS-232.
I have kept all its pins separate as it may be possible that I may have to connect 2 devices with RS-232 and RS-485 connections.
SO I am keeping both of them isolated
Hi
I am making a PCB to connect differnt devices to a microcontroller.
In it I am keeping slots/ports for connecting devices with different protocols.
In the same, I want to keep a slot for RS-485 connection.
However, I don't which wires should I take out from microcontrollers and which are...
rs485 connection
Hi
I need to connect an energy meter to a microcontroller.
The meter uses modbus protocol to transfer data.
How can I read it in PIC18F87J10.
modbus pic
Hi
I need to connect an energy meter to a microcontroller.
The meter uses modbus protocol to transfer data.
How can I read it in PIC18F87J10.
matlab calculate perimeter
Hi
go to each location of the image by using for loops (for x=...;for y=....)
and then check the conditions for he RGB intensity there.
Like R.200;G<...
to get your features.
This approach can be used in some cases.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
