Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Unfortunately, I already use Sigrity as the PowerSI tool is integrated into it... but I'm not an expert of it.
I tried to change several options and there is even a DC fitter that I use to calculate a DC response for the PCB and to change the S parameters simulation according to its results...
Hello Volker,
thank you for your answer.
your explanation makes sense.
as I would like to extract an electronic model to import into some spice simulator, I would prefer to have a correct DC model if I want to do some time simulations.
I will try to load the raw S parameters and "correct"...
Hello Volker,
thank you for your interest.
maybe I'm wrong but I would say that all Sij parameters should have a quasi-DC phase at 0.
here is a schematic of the board with its 12 ports,
the Sii parameters with a phase at 0 in DC,
and the Sij (with i different than j) parameters which have a...
Hello,
I use the Cadence PowerSI Model Extraction tool to get the S-parameters of a small and simple PCB.
this PCB is roughly a simple wire connecting 1 input connector to 1 output connector for 6 channels (then 12 connectors in total).
this PCB is about 15cm x 10cm large.
I'm surprised that...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
