Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
The input is 5V - on pin number 8, pin number 5 is connected to coil, the GND is only the heat-sink , the output I have no Idea what it should be, no manufacture logo, the bottom has heatsink, the coil is 1R5 (probably 1.5 micro henry)
I guess the voltage out can be anything between 3.3V to 1V...
Hi,
Does any body try already to work with these chips to implement H-Bridge?
I have build a circuit - but it doesn't work.
Also the datasheet to my opinion is very poor.
These chips are half bridge, and I am trying to build full bridge.
Attached schematic.
My questions:
1. Can this circuit work...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
