Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
I'm currently building a DC-AC Inverter! At the output i nid 50Hz 230V single phase. I would like to find out wad is the required input DC voltage for my DC-AC Inverter.
I am basically using a typical single phase full bridge inverter with 4 IGBT switches.
Regards,
Realm
Re: DC-DC down converter
Yeap Agree with Tahmid! As long as your load resistance is much much smaller than the resistances of the potential divider than it should work well.
Anyway your input and output voltage is a fixed or varying voltage?
Good Morning all,
I am trying to simulate a simple buck-boost DC-DC converter with a DC-AC full bridge single phase Inverter using matlab.
Basically i use simspowersystem to draw out the circuit and just try to simulate. However, I could not get the desired results.
Currently, i'm still...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
